Sift 150 Sieve

Product Description

During part extraction on the Fuse Sift, unsintered powder is dislodged and funneled into the sifter below the workspace. This 150 µm sieve filters out any small chunks or debris to keep the powder clean. The reclaimed powder can then be stored in a dedicated hopper until mixing with fresh powder for the next print.

Clumps of nylon can accumulate in the mesh screen below the surface grate, eventually preventing reclaimed powder from passing through to be collected. Formlabs recommends replacing the sifter mesh after every 200 hours of use. For reference, the sifter automatically turns off after 30 minutes by default, so 200 hours of use represents at least 400 full sifting cycles.

Installation guide

Compatibility

Printer compatibility: Fuse 1, Fuse 1+ 30W